Cesspool Pumping St Petersburg FL

As a septic system owner, you may want to try your best to stay septic safe. This is more important if you are around the opening of the septic tank. As a matter of fact, you should know all of the important safety precautions that should be taken prior to working on the septic system.

Follow the safety tips given below:

1. Septic tank lid
Make sure that the access port of your tank is covered with a solid lid. Make sure that the lid is strong enough. Kids should not be able to open it. If you have no idea as to how to install the system, you can call a professional for help. The company will be more than happy to help with the inspection.

2. The tank opening
You should never lean over the septic tank opening. The reason is that the gasses that come out of the tank may knock you out. You may also fall in the tank, which may prove fatal.

3. Driving Over The septic system
Driving heavy machine on the ground where the tank system is buried is not a good idea. Actually, you may have to bear heavy costs in order to get the broken pipes repaired. So, make sure you don’t drive heavy equipment or machinery on the ground where you buried the tank system.

Contact Info:
Name: Billy Fowler
Email: info@asapadvancedseptic.com
Organization: ASAP Advanced Septic & Drainage, Inc.
Address: 5011 E Busch Blvd, Tampa, FL 33617
Phone: (813) 986-6070

What is Involved in Septic Tank Pumping?

Septic Tank Soakaway

Septic tank problems often occur with systems that are onion- shaped. The liquids and solids in a septic tank are separated by a baffle that comes in the form of a ball-shaped figure, or an inner sleeve shaped skin that has hooks attached to it at the top of the inner side of the neck. However, the wear and tear in the passing years may tear off the baffle allowing it to sink in the tank. Also, the ball in the receptacle may be knocked loose and disentangle itself. Most septic system problems begin with these two scenarios because liquid and solid wastes combine as they go through the soak away and this may cause a blockage.

One way to address septic tank problems especially if the baffle collapsed is for a homeowner to set-up a filter for his tank. Filters like these can be placed by a homeowner inside an outlet pipe, so that the septic system can function more effectively not to mention that it can save one a significant amount of money. However, if problems are more acute, a homeowner has no other recourse but to replace his or her old septic tank. Another concern that is related to cesspit are open, loose, or worn-out manhole covers.

Other problems that can be resolved yourself are solids blocking the soakway. A T-bar can used to unblock the passage. This very basic baffle is made of clay, but for those who want to replace it with a current version. The replacements units are generally reproduced in plastic to save on cost. However, one has to be careful with these baffles because if they are not correctly installed, the solids will still enter the soakway unhampered causing more damage. A homeowner would perhaps consider buying septic tank filler for him to solve his septic tank problems himself and save on the installation costs. On the other hand, this type of job is often better handled by a professional who isn't afraid to get his hands dirty.

 

Septic Tanks - A Necessity for Our Environment

Sepsis Infection

Septic System Guidelines

There are ways to keep private septic systems from getting damaged. Mostly older houses have private septic systems and not public sewer systems. The way to find out if your house has a septic tank is to ask the owner if you are a renter; and ask the previous owner if you are the current owner paying mortgage.

Prevent septic tank 'back ups' and septic tank pumping by following the tips below.


Things to do to prevent septic system damage - Do's and Don'ts

  • Do throw diapers in the trash.
  • Do throw feminine products in the trash.
  • Do use toilet paper that is "septic tank safe" such as 'Scott Toilet Tissue 1,000 Sheets.'
  • Do flush toilet when there is just only water in the toilet bowl, to keep pipelines clear and to prevent the pipelines from backing up.
  • Do flush toilet 3 times before pouring Rid-X down into the toilet.
  • Do once a month flush 1 whole container of 'Rid-X' down the toilet then flush. Best results; flush Rid-X down the toilet when everyone in the home has went to sleep at night. (Follow instruction on the product label).
  • Do flush again only water and not toilet paper, 3 times the next day; to help clear out the pipes.


Septic tank health tips

  • Don't flush massive amounts of toilet paper (dispose of it in the trash).
  • Don't flush any type of feminine products; panty liners, kotex, tampons, wrappers, or pads.
  • Don't flush any diapers, throw them in the trash.
  • Don't flush paper towels or baby wipes, put them in the trash.
  • Don't put food down the kitchen drain or garbage disposal, throw in the trash. Garbage disposal is for very small amounts of food.


© Sabrina A.K.


Septic Treatment Solutions - Do They Work?

septic care tips

Septic tank systems become clogged with roots in the leach lines, leach field, drain field or seepage field, causing backup of wastewater into the house. The inexpensive fix is to use copper sulfate through an installed cleanout or septic field pump.

Septic tank systems

Septic tank systems do not last forever and replacing one is a very expensive proposition. If your house is connected to the city sewer system, then you do not have a septic tank. A septic tank can be described as your very own little sewage treatment plant. There are three basic elements of a septic system:

  1. The septic line that carries sewage and waste water from your house to the tank. There is usually a cleanout plug at the house-end it so that you can run a snake down it to remove obstructions.
  2. The septic tank itself where sewage is held while undergoing decomposition. This is underground, probably under a grassy area, and has a cover that is usually buried in residential installations.
  3. The leach field, also referred to as a drain field or seepage field. This is a branching network of underground porous trenches, pipes or something similar that carries the clear liquid from the septic tank throughout adjacent soil where it is absorbed.

A clogged leach field

Eventually leach fields become clogged because the roots from trees and other vegetation are attracted to the nutrient-rich effluent. The roots grow through the pores intended to drain the liquid, seepage gradually slows or stops.

If sufficient pressure cannot be released through the pores of the leach field, the entire septic system cannot accept any more waste water and it backs up in the house, usually at a low point such as a shower or tub drain. If it gets that bad, you may have to replace the entire leach field. In many localities, that will require a building permit and meeting current building codes, which means replacing the entire septic system, which is expensive, etc.

Kill roots with copper sulfate

Since this is obviously something to avoid, you can often extend the life of the old system by taking action when sewage flow has slowed, but not completely stopped. Copper sulfate kills roots. If it can be placed into the system so that it will flow through the leach field, the roots will die (but not the plants) and waste water will begin to flow more freely again after a few weeks. In many systems, this isn’t as easy as it sounds, because copper sulfate is so heavy that it will settle to the bottom of the septic tank unless inserted into the leach line leading from the tank. If you have a cleanout or other access there, you’re all set, but many residential systems do not. I prefer the crystal form over the powder because it's easier to handle, cheaper and dissolves more slowly, .

Install a leach line cleanout

If necessary, it is not very expensive to have a cleanout installed in the leach line expressly for the purpose of adding copper sulfate periodically. If that still doesn’t quite work, or if you want to be sure the stuff is going to flow more quickly, you can pump it through the leach field.

It is possible to install a pump on the leach line cleanout between the septic tank and the leach field. It can be buried below ground level or installed above ground and concealed with landscape bushes. The pump turns on and off automatically to maintain a slight pressure on the waste water, pushing it through the pores of the seepage field. Adding copper sulfate at intervals through a cleanout at this point is effective to drive the chemical towards the offending roots.

Killing the roots may extend the life of the septic system a few years, but it will ultimately need to be replaced with a completely modern one—unless you can successfully lobby for a neighborhood hook-up, of course.

Tips on Preventing Septic System Back-up

Drain Grates

Improper maintenance of your safety tank could jeopardize the safety of your health, finances and of course the environment. Leaks, blockage and sludge build-up in the tank could contaminate the groundwater, soil and the even the nearby water bodies. Following the following septic tank maintenance tips will help keep your tank in good shape.

Make Sure To Protect The Tank And The Drain Field

Safeguarding your tank from any physical damage would ensure the longevity of your septic tank. Never plant anything other than grass around your septic system. This is because the tree roots are capable of damaging the system. It is also suggested that you don't operate any heavy machinery near the tank or build a shed or structure above the system.

Keep rainwater away from the drain field

A soggy drain field leads to improper neutralization and absorption of liquid waste. Therefore go for roof gutters, landscaping and foundation drains to divert all the extra water from the septic drain field.

Go For Regular Maintenance

The solids in your septic system need to be pumped out from time to time. Ideally you need to pump your septic tank every three to five years to ensure its longevity. It needs to me mentioned that you should never attempt to open your septic system on your own since it contains poisonous gases and bacteria.

So, these are a few precautions that you may want to take if you are going to work on a septic tank system. This is important should you want to keep you and your family safe around the system. When in doubt, it’s a good idea to call a local septic service in St Petersburg FL . Hopefully, these tips will help.

SEPTIC TANK CARE | WHO TO CALL FOR SERVICE IN St Petersburg FL

Installing septic tank pump system becomes necessary for all those homeowners who live in the area having no municipal sewage system. These tanks are quite effective in treating and disposing off your discarded products. You should take special care in maintaining this tank pump system. Sometime homeowners also involve themselves in installation process.

Sometimes installing a septic tank pump becomes necessary especially in higher elevation areas. This pump works exceptionally well in pumping sewage to a distribution tank from septic chamber. Thus it ensures functionality of overall septic system. Though majority of septic systems is based on gravity but this assistance becomes impractical and sometimes impossible in some cases due to distance or terrain.

You should consider installing a pump in the septic tank in this situation just to ensure smooth supply of water to the filed lines directly from the tank. Well, this is a common technique that gives considerable difference from typical setup process of a septic tank system. Consider following step by step guideline to install your septic tank pump:

4 - Use direct burial wiring to connect pump motor with electricity. It is recommended having separate breaker for the pump motor. An added protection to pump could be placing Ground Fault Circuit Interruption breaker because such devices reduces electrical shocks or short circuit issues. Considering expert help is recommended especially if you don't know much about electrical wiring.

5 - Now add some water to your tank just to test the pump. The pump should activate itself once the tank reaches its predefined depth level. Shut off the pump once it moves out water. In the end, septic tank should be covered once you get confirmation that your septic tank pump is functioning properly.


Pinellas Leach Field Replacement

Home